HITACHI NV50AP3 2" PLASTIC CAP COIL NAILER: FeaturesLightweight at only 5.52 lbs., the NV50AP3 is over 20% lighter than the NV50AP2 for less user fatigue Plastic and metal caps, whether shooting plastic caps or metal caps, this tool meets your needs Drives nail and caps in tandem for better hold Selective actuation, a simple flip of the switch allows for either sequential or bump fire nail- no additional parts or tools required Translucent cap and nail magazine, a simple glance confirms the remaining supply of both fasteners and caps, avoiding inconveniently timed reloads Tool-free depth adjustment, simple adjustment provides flexibility when fastening various materials Drives 350 caps and 350 nails for maximum jobsite efficiency Exceptional Hitachi balance and fully adjustable exhaust make this the ideal tool for Tyvek installation, tar paper and any other sheathing Includes: Safety Glasses Specifications Actual Weight 5.52 lbs Length 14-9/16" Height 10-19/32" Width 9-1/4" Operating Pressure 70-120 Nail or Staple Nail Cap Capacity 350 Nail Capacity 350 Fastener Length 7/8" - 2" Washer Type Plastic and Steel (Roll) Depth Adjustment Tool-less Adjustable Exhaust Yes Fastener Type Nail Full Round Head-Wire Collation Fastener Type Cap Plastic/Plastic,Steel/Tape Fastener Diameter Range .083 Magazine Angle 16 Degrees Magazine Loading Nails/Side, Caps/Side Air Inlet 3/8" Actuation Selective (sequential/contact) Air Consumption .042 |